About this Product
Functional BadUSB earrings - Each set of two earrings are handmade with a skull and rose design on the front and the components on the back. These earrings use a modified version of the Vidar circuit to utilize USB-C connectors for maximum compatibility. Setup instructions can be found at https://rot13labs.com/setup/vi...
These can be purchased as fully built badUSB earrings, DIY kits containing the boards and all components, or as just bare boards for those who don't need the full BadUSB functionality or wish to source their own parts to build these. (NOTE: soldering the 24 pin USB-C connector will require a hotplate or reflow oven. These cannot be built using only a traditional soldering iron!) BOM for bare boards DIY versions can be found below. Part placement shown in images.
BOM___
2 x DIODE ZENER 3.6V SOD123
2 x RES 5.1K OHM 0603
2 x RES 68 OHM 0603
1 x RES 2.2K OHM 0603
1 x ATTINY85 8BIT 8SOIC
1 x CONN RCPT USB C 3.2 24POS SMD
rot13labs
Meet the Maker
rot13labs has been making electronic badges since 2020 and is best known for badges such as Hackbutt and the BSides Tampa electronic badges.
